Use this guide to connect the AtomStack R8 rotary chuck, set the workpiece size in your software, and test the rotation before engraving. Start with your engraver model to find the right cable and port.
Power off the engraver before connecting or disconnecting the rotary. Use the cable specified for your machine.
| Engraver | R8 cable and connection | Clearance and setup |
|---|---|---|
| P1 | Supplied USB-ended auto-recognition cable → Accessory port | Remove the base plate and install the H5 raised feet. P1 user guide |
| Swift | Supplied USB-ended auto-recognition cable → Extension port, also called the accessory port in the guide | Use the Swift threaded riser feet. Swift user guide |
| Kraft | Supplied USB-ended auto-recognition cable → Accessory port, marked 12 in the panel diagram | Install the H4 riser. Kraft user guide |
| Atelier | Supplied USB-ended auto-recognition cable → Accessory port | See the rotary connection video for the machine setup. Atelier video center |
| Glacier | Supplied USB-ended auto-recognition cable → ACCESSORY port on the control box | Use the matching risers. Glacier user guide |
| A70 Pro / A70 Max | White-connector sequential motor cable → engraver-side Y-axis motor plug | With power off, disconnect the Y-axis motor, then connect the R8 to the machine-side plug through the sequential cable. Use the specified threaded risers if clearance is needed. A70 user guide · A70 FAQ |
For another model, check the official R8 compatibility table and the engraver's rotary instructions before connecting. If you need a replacement cable, send support your exact engraver model and a photo of the connector you need to use.

Auto-recognition cable for the accessory port.
| R8 workpiece shape | Diameter range |
|---|---|
| Cylindrical | 0–80 mm |
| Spherical | 25–80 mm |
| Ring-shaped | 10–70 mm |
The R8 has a maximum load of 1.5 kg. Check that your engraver has enough clearance for the mounted part. R8 limits in the Glacier user guide

Use the R8 panel on the left as a reference for the fields, and switch on Enable Rotary before testing.
| What you see | What to check |
|---|---|
| R8 is missing in Studio or does not turn | Verify the cable and port in the table. On an auto-recognition model, check that the supplied cable is fully seated in the accessory port. In LightBurn, check that the rotary is enabled and set to Chuck and Y Axis. |
| The chuck stutters, keeps turning, or the machine cannot home | Stop the machine and power off before checking the cable. Follow your machine's rotary and homing instructions before retrying. Glacier motion and homing · A70 motion and homing |
| The design is stretched, compressed, or the ends of a wrap fail to meet | Run a rotation test. If it makes one full turn, remeasure the engraving band and check that the workpiece is centered and stays fixed in the jaws. |
| The design is mirrored | Check the mirror setting in your software and verify the change on a small test. Atelier mirror settings and screenshots |
If the problem continues, email [email protected] with your engraver model, photos of the cable and the connected port, a screenshot of your rotary settings, and a short video of the movement.